V mesh fencing, priced by the metre
V mesh, 656 and 868 twin wire and 358 anti-climb panels for schools, pitches, business parks and playgrounds. What each costs, how high a fence can go without planning, and what a good quote includes.
Free and no obligation. Your request goes to one fencing contractor in your county, not a list.
- €25–€40 a metreV mesh 1.8 m high: panels, posts and clamps
- €45–€59 a metre868 twin wire at the same height
- 1.2 mthe tallest new fence exempt from planning away from a house
- about 5 daysfor stock panels and posts to arrive
Price your mesh fence
Three taps and the kit price shows as you go. Your name and number come last, and only if you want a contractor to price the fitting.
V mesh, 1.8 m high, 25 to 50 m: €625 to €2,000.
How the price is worked out
The figure is what Irish sellers charge for the panels, posts and clamps a metre, with VAT, times the length you pick. Where sellers differ you see the lowest and the highest. 358 mesh and ball-stop fences are priced to the site. Fitting is not in the figure: a contractor prices it after walking the line. Use it to plan with. It isn't a quote.
The mesh, panel by panel
Six ways to fence a site with welded mesh. Each has its own page with prices and what to check.
From a price to a fence in three steps
1Price it herePick the mesh, the height and the length. You see the kit price as you tap, before the planner asks for anything.
2One contractor walks the lineSend it and a single fencing contractor in your county rings to arrange a visit. They measure the run, check the ground and price the job in writing.
3It goes upStock panels and posts can arrive in about 5 days. Posts go in first, then the panels are clamped on.
What a metre of fence costs
Panels, posts and clamps at Irish prices, VAT in. Tap one for every height.
V mesh
from €23 a metrepanels, posts and clamps, VAT inSee more →656 twin wire
from €30 a metreflat panels, 6 mm twin wiresSee more →868 twin wire
from €38 a metreflat panels, 8 mm twin wiresSee more →358 anti-climb
priced to the site1.8 to 3.0 m highSee more →Gates
from €265 a gateposts included, VAT inSee more →Ball-stop and pitch-side
rail about €60 a metrenetting and posts priced to the pitchSee more →Fitting is priced after a site visit, on top of the kit. Every height, gates and worked runs: V mesh fencing cost.
V mesh, twin wire or 358?
The panel decides the price, the look and how hard the fence is to get through.
V mesh
- Wire
- 4 or 5 mm, single
- Openings
- 50 × 200 mm
- Panel
- Folded across for stiffness
- At 1.8 m, a metre
- €25 to €40
- Heights
- 1.03 to 2.43 m
- Its page
- V mesh panels
656 and 868 twin wire
- Wire
- 6/5/6 or 8/6/8 mm, two wires a crossing
- Openings
- 50 × 200 mm
- Panel
- Flat, no folds
- At 1.8 m, a metre
- €33 to €45 or €45 to €59
- Heights
- 1.23 to 2.43 m
- Its page
- V mesh or twin wire
358 anti-climb
- Wire
- 3.8 mm
- Openings
- 76.2 × 12.7 mm
- Panel
- Flat, very tight
- At 1.8 m, a metre
- On request
- Heights
- 1.8 to 3.0 m
- Its page
- 358 mesh
Panel heights
Panels come in steps from about a metre to 2.43 m. The price a metre climbs with them.
A 1.23 m panel is already 3 cm over the 1.2 m a new fence can be without planning permission, before the gap under it. Taller fences, such as ball-stops at the end of a pitch, stack panels on longer posts. Heights and panel sizes.
The names people mix up
Twin wire
A flat panel with two horizontal wires at every crossing: 656 or the heavier 868. No folds.
358
A tight mesh of 76.2 by 12.7 mm gaps, which is 3 inches by half an inch. Sold as anti-climb or prison mesh.
The planning rule in four limits
For a fence round a school, a pitch, a yard or a park: anywhere that is not a house.
- 1.2 m for a new fence. Away from a house, a new fence up to 1.2 m high is exempt from planning permission.
- Like for like. A replacement can be as tall as the fence it replaces, if that is higher than 1.2 m.
- Never over 2 m. No fence taller than 2 m is exempt under this rule, new or replaced.
- Not on land the public uses. Fencing in land the public has used for recreation for the past 10 years is not exempt at any height.
A section 5 declaration from the council settles whether a fence is exempt. It costs €80, and the council has 4 weeks to decide. The whole rule, with the cases that lose the exemption: planning permission.
Every county, one contractor
The planner asks for your county last.
Requests come from all 26 counties: Leinster's 12, Munster's 6, Connacht's 5, and Cavan, Donegal and Monaghan. Each one goes to one fencing contractor who covers your county. There is no list and no ring-round. Stock panels and posts can be delivered in about 5 days, and some panels take 7 to 14 days. Mesh gates take 2 to 3 weeks.
Counties covered, with the council that takes planning questions in each.
What a good quote includes
Five things to see in writing before you say yes.
- The mesh. V mesh, 656, 868 or 358, the wire in millimetres and the panel height.
- The length. Metres of fence, with the number of panels, posts, corners and ends.
- Posts and fixings. 60 × 40 or 60 × 60 mm posts, dug in or bolted down, clamps or clips, and security bolts.
- The ground. Digging, post mix, and any concrete or tarmac to break out or bolt into.
- The slope. Whether the panels are stepped, and where.
The other five, and why each matters: what a good quote includes.
Before you start
How much does V mesh fencing cost?
V mesh fencing costs €25 to €40 a metre for a 1.8 m fence and €33 to €58 a metre at 2.4 m, bought as panels, posts and clamps with VAT. 656 twin wire is €33 to €45 a metre at 1.8 m and 868 twin wire €45 to €59 a metre. Fitting is priced after a site visit, because the ground, the corners and the gates set it. The full price guide.
Do I need planning permission for a mesh fence?
Away from a house, a new fence is exempt from planning permission up to 1.2 m high, or up to the height of the fence it replaces, and never over 2 m. A new 1.8 m or 2.4 m mesh fence round a school, a pitch or a yard needs permission unless it replaces one as tall, up to 2 m. Planning permission.
What VAT is charged on fencing?
Bought on their own, panels, posts and gates carry VAT at 23%. Supplied and fitted as a permanent fence, the job is at 13.5%, unless the materials come to more than two-thirds of the price before VAT, when 23% applies to the lot. VAT on fencing.
What is the difference between V mesh and twin wire?
V mesh is single wire, 4 or 5 mm, stiffened by folds pressed across the panel. 656 twin wire has two 6 mm wires at every crossing on 5 mm uprights, and 868 two 8 mm wires on 6 mm uprights. All three have 50 by 200 mm openings. V mesh or twin wire.
How high can a mesh fence go?
Single panels go up to 2.43 m. Taller fences stack panels on longer posts. Away from a house, anything new over 1.2 m needs planning permission.
How long does delivery take?
Stock panels and posts can be delivered in about 5 days, and some panels take 7 to 14 days. Mesh gates take 2 to 3 weeks.
Can a sports club get funding for a fence?
The 2026 Community Sport Facilities Fund (CSFF) lists security fencing and fixed ball-stop netting among the works it pays for. Applications close at 5pm on 26 February 2027, and a project where work starts before an offer is made is ruled out. Funding for clubs and schools.
Who rings me if I send my fence?
A single fencing contractor in your county, who already has your answers and our price. Your details go nowhere else. The contractor walks the line of the fence, prices the job in writing, and you decide whether to go ahead.
Everything on this site
Mesh and gates
For your site
See the kit price before anyone rings
Pick the mesh, the height and the length. When you want a fitted price, it goes to a single fencing contractor in your county.
